Step 1: Opening the box:

Pull the bottom of the latch, and slide the top part off of the latch.

Here is what you will find inside:

 

Step 2: Take out the microphone

Step 3: Remove the mic stand holder at the bottom.

Here is a look at the microphone with the stand taken from the side:

And from the bottom

You will need to twist the ring on the bottom holding the mic stand in place

After you get done, you will have three pieces:

 

You only need to keep the microphone out (silver part), put the two black pieces back into the case:

Step 3: Take out the Microphone holder that is made of a silver metal with a black cord:

Step 4: Attach the microphone to this.

It fits into the stand like this:

But you have to twist the silver disk at the bottom to make it stay on:

 

Afterwards, make sure the label is facing on the opposite side as the part that is sticking out.  Like this:

Step 5: remove the inner silver disk from the part that is sticking out by twisting it:

and put it back into the case:

 

Step 6: Attach the microphone holder rod.

Remove the Rod from the case:

The silver part goes into the silver stand:

Twist it until it is tight

Step 7: Loosen the screw that allows for you to adjust the direction of the microphone pole

Now it should move freely up

 

and down

 

Step 8: Attach the Microphone base to the rod

Remove it from the case

Attach by twisting

Now it should be like this:

 

Step 9: Setup the microphone up right:

 

Lift the Microphone up so it is not touching the bottom

 

Tighten the screw on the side to hold it in place

It should be like this:

Make sure that the label on the microphone is still facing front:

Step 10: Hook up the USB cable

remove from case

Turn the microphone on the side

plug the square looking side into the bottom.  Only one of the sides will fit in.  And it will only fit in one way.

Turn the microphone back up, and it should be like this:

Step 11: Hook the USB cable to the computer

•